garage door springs

 

Your garage is a personal space, a space where you work, where you can be creative, and why not, a place where you can rest. It is very important to make this space a pleasant and functional one, because if otherwise your creativity and productivity won’t reach the highest level. There are plenty of things that can go wrong in your garage, and probably one of the biggest disasters that can strike about your garage door, is a broken tension spring. This is a main part of your garage door system, because when the garage door springs are broken you won’t be able to lift the door. The springs are making a balance between the door and the gravity, and when they are out of function, the gravity is pulling your garage door to the ground. There are two types of garage doors: the first one with the system that operates with two springs, one on each side of the door, and the second one that operates on one spring which is located in the middle. In this article, we are going to explain an easy step of replacing that middle string. Apart from garage door openers we also provide garage door repair services in Minneapolis MN.

One-piece extension springs are balancing the weight of the door when the door is open. There are tracks above the door, and when the door is opened this part goes inside, while the bottom part goes outside along with the door. This bottom part is connected to a door with a jamb bracket, while the top is connected to clip or a loop that is placed over a bolt.

The first thing to do is to unplug the garage door opener cord, so you would cut its power supply. Then you’ll have to disengage the opener of the door, and then open your door. During the whole process your door will have to stay open, so support it with some concrete blocks or something similar. Be sure that they won’t move since it can harm you. You can also use a strong ladder if you have one. Now you will have to check below the bottom of the spring, and find the nut to lose. After this you can remove the old spring, and check to see if the top pivot bolt is worn. Check your shaft and bearing, and if there is a need it’s better to replace them with some nuts, washers and bolts. Grease them good while you are there. After this you can put the new spring and tight the bottom and top nut. Repeat the same process for both top and bottom spring, and check to see if everything is in order before you close the door.

If you are not very experienced, or if you are not sure that you can do this on your own, it is better to call garage door professionals so they can assist you with your problem. However, if you decide to work on your own, be very cautious and careful since the replacement of a tension spring can be a dangerous job.If you opt to go the professional way, and your are located in Minneapolis region, then, you will satisfactorily get this services and more from Minneapolis Garage Door Experts.

For more business information you can see at

yelp